![]() ![]() TEREK pumps are air driven at a drive air pressure of 3 to 8 bar (29 to 116 psi) by the normal air compressor. ![]() The automatic reciprocating motion of the piston is controlled by a built-in four-way valve. Basically the principle of operation is similar to a reciprocating amplifier where control of the piston at the end position is reciprocating , By multiplying the pressure ratio by the available shop air pressure, the nominal liquid pressure can be calculated. The outlet pressure is easily to set through a simple regulator. TEREK model reflect the pumps nominal pressure ratios, while the technical data indicates exact ratios. Higher pressures obtained by using higher pressure ratios. The pressure ratio is the difference of these two areas and is the method of determining maximum outlet pressure. TEREK pumps feature is a large air piston joint to a smaller diameter piston. The pump will stop working automatically when the output pressure reaches the preset value, The pump will start automatically when the outlet pressure drops slightly or the air drive pressure increases. The structural design of the Fluid pressurized control cabinet are compact and according to the special requirement of customers, Combined the air driven fluid booster pumps,valves ,control switches and other precision accessories are assembled in the frame or closed cabinet. The output pressure is produced by pneumatic booster pump, Therefore the electric connection will not be necessary. The maximum operating pressure up to 50000psi. The hydraulic device can be used for pressure testing of various components, research and testing institutions and industrial pressure field.īooster pump have a variety of pressure ratios, These series of pumps are ideal choice for various hydraulic power operations. When the driving air pressure and output pressure are balanced, The pump will automatically stop the filling pressure, and the output pressure will remain at the preset value. The ideal working high pressure can be achieved by adjusting the driving air pressure. The corresponding sign will also be marked on the panel. The pressure gauge,valve and pressure regulator will be mounted on the panel. The main parts of the equipment are assembled in closed stainless steel cabinet or stainless steel frames. The fluid pressurized control cabinet has been equipped with the fluid booster pump,the drive air water filter,the pressure regulator valve, Pressure gauges and manual pressure relieve valve. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |